Programming a New Line into the system

To enter a programming session, follow the next few simple steps:

1) Press FEATURE * * 2 6 6 3 4 4

2) Enter Password: 2 6 6 3 4 4

Display will read: " Terminals & Sets"

Using the navigation keys, as displayed below, follow the next simple steps:

3) Press: NEXT

Display will read: "Lines"

4) Press: SHOW

Display will read: "Show Line"

5) Press: SHOW

 Display will read: "Trunk Line Data"

7) Press: SHOW

Display will read: "Trunk Type: Loop"

8) Press: NEXT

Display will read: "Line Type: ____"

9) Press the "CHANGE"softkey.

Until you see: Pool A

10) Press: N

Display will read: "Dial Mode: Tone

11) Press: NEXT

Display will read: "Prime Set: ___"

This will be the operators extension number

Press the change "softkey" and enter the operators extension

number

12) Press: NEXT

Display will read: " Auto Privacy : Y_"

13) Press: NEXT

Display will read: "Trunk Mode: __"

Press the change "softkey" until you see Super

14) Press: NEXT

Display will read: "Ans Mode: Manual

 15) Press: NEXT

Display will read: "Aux Ringer: N"

16) Press: NEXT 

Display will read: " Full auto Hold: N"

17) Press: NEXT

Display will read: "Loss Pkg: Medium Co"

Congratulations! You have successfully added a line to your system!

 

 
All RIGHTS RESERVED. © 2004-2012 PRO TELEPHONE TECHNOLOGIES