Programming a New Line
into the system
To enter a programming session,
follow the next few simple steps:
1) Press FEATURE * * 2 6 6
3 4 4
2) Enter Password: 2 6 6 3
4 4
Display will read: "
Terminals & Sets"
Using the navigation keys, as
displayed below, follow the next simple steps:
3) Press: NEXT
Display will read: "Lines"
4) Press: SHOW
Display will read: "Show
Line"
5) Press: SHOW
Display will read: "Trunk
Line Data"
7) Press: SHOW
Display will read: "Trunk
Type: Loop"
8) Press: NEXT
Display will read: "Line
Type: ____"
9) Press the "CHANGE"softkey.
Until you see: Pool A
10) Press: N
Display will read: "Dial
Mode: Tone
11) Press: NEXT
Display will read: "Prime
Set: ___"
This will be the operators
extension number
Press the change "softkey"
and enter the operators extension
number
12) Press: NEXT
Display will read: " Auto
Privacy : Y_"
13) Press: NEXT
Display will read: "Trunk
Mode: __"
Press the change "softkey"
until you see Super
14) Press: NEXT
Display will read: "Ans
Mode: Manual
15) Press:
NEXT
Display will read: "Aux
Ringer: N"
16) Press: NEXT
Display will read: " Full
auto Hold: N"
17) Press: NEXT
Display will read: "Loss
Pkg: Medium Co"
Congratulations! You have
successfully added a line to your system!
RETURN TO
PREVIOUS PAGE
| 
